Set of two original replacement gaskets for the VForce reed valve system by Moto Tassinari. Please note, all gasket part numbers that end with "-K" include two gaskets. Place one gasket on each side of the VForce manifold during installation. One "-K" set is enough gaskets for one reed valve. If you have a twin, you will need to order two "-K" sets to have the required four gaskets.
Each time you inspect your reeds for wear (which you should be doing twice a season) you should always replace the gaskets to make sure the seal has not and will not be compromised. Always replacing gaskets is cheap insurance against air leaks which can ultimately lead to severe motor problems such as sucking dirt or an extremely lean condition.
ATTENTION! California Residents: Proposition 65 Warning
Write Your Own Review